Home

Welcome to OnlineConversion.com

V-belt sizing
 

V-belt sizing
by Rubicon on 08/02/02 at 11:03:53

Does anyone know of an internet resource that gives v-belt pitch diameters based on nominal belt size (i.e. BX34, etc.)?
Thanks


Re: V-belt sizing
by Chester on 08/05/02 at 10:52:22

Don't know the answer to that one, but if you post on www.chaski.com/cgi-bin/machine_index.cgi   or the board on www.homeshopmachinist.net/    someone there is sure to have a solution.     Hope that helps.

Chester


Re: V-belt sizing
by Noel on 08/26/02 at 23:55:04

 Try Gates Rubber Corp (www.gates.com)


Go Back | Archive Index


 

Did you find us useful?

Please consider supporting the site with a small donation.

click here for more information

 


BookMark Us

It may come in handy.

Check out our Conversion Software for Windows.

Can't find something?
Try searching.

Are you bored?
Try the Fun Stuff.

Was this site helpful?
Link to Us | Donate